Index R200 Operating Instructions And Maintenance Instructions page 40

34
Example: Cooling lubricant reconditioning R200
1 Drive for fleece or paper belt filter
2 Display for cooling lubricant temperature
3 Display "Power" on/off
4 Display "Warning"
5 Main switch
6 Display Min./Max.
Clean screens and magnetic filter plates (option). To avoid clogging of the
cooling lubricant channels, the insert screen, coarse screen and the magnetic
filter plate (option) should be cleaned weekly or as appropriate depending on
the degree of contamination of the chip conveyor. Insert a second, non-built-in
insert screen at the motor side. This prevents sludge deposits and chips from
entering the suction area of the pump. Then remove and clean the dirty screen,
and have it ready for the next maintenance interval.
6. Remove and clean pre-filters (option) on the cooling lubricant pump.
7.
If the supply of cooling lubricant is insufficient, the filter basket
on the cooling lubricant pump must be cleaned.
Remove cooling lubricant pump. Remove and clean filter basket on the cooling
lubricant pump.
Alternatively, the following procedure can be used!
Extract cooling lubricant, remove screen directly from the cooling lubricant
pump and clean it.
Maintenance Summary - Care activities
Maintenance Instructions
LR1702.10181 - 05.06.2019
R200