Boomprime; Before Returning To Refill The Sprayer; Parking The Sprayer - Hardi COMMANDER DELTA FORCE Instruction Book

5 - Operation

BoomPrime

The BoomPrime system works automatically, and it is activated, when a spray job is prepared:
1. Turn on the PTO.
2. Set pressure valve to "Spraying", suction valve to "Main tank" and
agitation valve to "Agitation", if needed.
3. Adjust the spray pressure to what will be used when spraying.
4. The boom will then be fully primed within 1-2 minutes.
If the nozzles start to drip, when closing one or more boom sections
during a spray job, proceed as follows:
1. Adjust the pressure on the BoomPrime pressure regulation.
2. Turn pressure valve to "Main tank".
3. Disconnect the PTO.
If adjustment of the BoomPrime system might be necessary, please refer
to the section "BoomPrime Adjustment" on page 96.

Before Returning to Refill the Sprayer

If the sprayer is to be refilled at the farm, or at a fixed filling place without a filling space with hard surface and drain to a
closed reservoir, the sprayer should be rinsed before returning to refill.
Dilute the residues of the spraying circuit, and spray it on the crop. Depending on the weather conditions, it could also be
necessary to clean the sprayer on the outside now while in the field, before returning to the farm.
±
WARNING! Always follow local legislation in force at any time.

Parking the Sprayer

To avoid spot contamination, the sprayer should always be parked at either the washing/filling location or under roof.
This prevents rainfall from washing down chemical residues from the sprayer's surfaces.
• Parking at the washing/filling location will retain residues.
• Always park the machine out of reach of children, animals and unauthorized persons.
• Always follow local regulations when parking your sprayer.
124