Front Panel Features - Extron electronics NAV SD 511 User Manual

Streaming hdmi scaling decoder
Hide thumbs Also See for NAV SD 511:
Table of Contents

Advertisement

ATTENTION:
To verify the polarity before connection, plug in the power supply with no load and check the
output with a voltmeter.

Front Panel Features

NAV
VIDEO
CONFIG
HDCP
A A
A
B
B B
C
C C
Figure 8.
A
B
C
D
A
B
Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling
spaces or in wall cavities.
Sauf mention contraire, les adaptateurs AC/DC ne sont pas appropriés pour une
utilisation dans les espaces d'aération ou dans les cavités murales.
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to a
building structure or similar structure.
Cette installation doit toujours être en accord avec les mesures qui s'applique
au National Electrical Code ANSI/NFPA 70, article 725, et au Canadian Electrical
Code, partie 1, section 16. La source d'alimentation ne devra pas être fixée de
façon permanente à une structure de bâtiment ou à une structure similaire.
Power supply voltage polarity is critical. Incorrect voltage polarity can damage the
power supply and the unit. The ridges on the side of the cord (see
page 11) identify the power cord negative lead.
La polarité de la source d'alimentation est primordiale. Une polarité incorrecte
pourrait endommager la source d'alimentation et l'unité. Les stries sur le côté du
cordon (voir
l'illustration 7
cordon d'alimentation.
AUDIO
USB
AUDIO
HDMI
HOST
USB
ANALOG
ACTIVE
D
D D
E
E E
Decoder Front Panel Features
Power LED (see below)
Configuration port
NAV LEDs
(see page 13)
Audio LEDs
Power LED — Indicates power and startup status, as follows:
Blinking — The unit is receiving power and is booting up.
Lit — The unit is receiving power and is operational.
Configuration port — This USB mini-B port (USB 2.0) can be used to configure the
decoder and to update firmware.
sur la page 11) permettent de repérer le pôle négatif du
USB LEDs
E
LAN LEDs
F
ID button and LED
G
NAV SD 511 Scaling Decoder • Installation
figure 7
on
LAN
ID
NAV
EXT
-LNK-
-ACT-
NAV SD 511
F
F F
G
G G
12

Advertisement

Table of Contents
loading

Table of Contents