Extron electronics NAV SD 511 User Manual page 52

2. Select (click) a reset level (see
NOTES:
• Reset Device Settings (Retains TCP/IP Settings and Password) —
Resets configuration settings. All communication settings and the password
are retained. See the
page 41.
• Reset All Settings and Delete Files (Retains TCP/IP Settings) —
Resets configuration settings except the communication settings, which are
maintained. Resets the password to the default, which is extron. See the
table
of communication and configuration settings.
• Reset All Settings and Delete Files — This reset is identical to the Mode 5
reset (see the table
3. Click APPLY ( ).
4
The decoder reports that it is Resetting and Rebooting
and displays a status bar that shows the progress of the
operation. Any of these operations concludes with the
decoder rebooting.
NOTE: You must reconnect to the decoder (see
Opening the Embedded HTML Pages
if you have additional operations to perform.
figure 38, on page 43) or Reboot (
2
table of communication and configuration settings on
of rear panel reset modes on page 16).
on page 18)
NAV SD 511 Scaling Decoder • HTML Operation
).
3
44