Speed Limiter (If Equipped) - Suzuki SWIFT 2022 Series Owner's Manual

OPERATING YOUR VEHICLE
NOTE:
• You can adjust the set speed by approxi-
mately 1 km/h (1 mph) by pushing
"RES +/SET –" switch quickly.
• When the current vehicle speed is about
10 km/h or more faster than the previ-
ously set speed, the cruising speed can-
not be decreased even if the "RES +/
SET –" switch (3) is pushed down.
• When the current vehicle speed is about
10 km/h or more slower than the previ-
ously set speed, the cruising speed can-
not be increased even if the "RES +/
SET –" switch (3) is pushed up.
Cancelling cruise control
"SET" indicator light (5), "SET" indicator (7)
or (9) will go off and the cruise control will
be canceled temporarily with the following
conditions:
• Push "CANCEL" switch (2).
• Depress the brake pedal.
• For manual transmission, depress the clutch
pedal.
• For automatic transmission
downshift from 3rd to 2nd in the manual
mode.
• For CVT vehicle, the gear position is
changed to "L"
• The vehicle speed falls more than about
20 percent from the set speed.
• Any time the vehicle speed falls below
40 km/h (25 mph).
3-69
• When the vehicle skids and ESP
activated.
To resume the previously set speed, push
up the "RES +/SET –" switch (3) and turn
on "SET" indicator light (5), "SET" indicator
(7) or (9). The vehicle speed must be
above 40 km/h (25 mph) when the vehicle
is not under the above conditions.
To turn off the cruise control system, push
cruise switch (1) and check that the cruise
indicator light (4), cruise indicator (6) or (8)
is off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.
vehicle,
®
is

Speed limiter (if equipped)

The speed limiter allows you to choose a
maximum speed that you do not wish to
exceed.
Setting maximum speed
Speed limiter switch
EXAMPLE
(1)
(1) "LIMIT" switch
(2) "CANCEL" switch
(3) "RES +/SET –" switch
(3)
(2)
80SM009