Driving On Slippery Roads - Suzuki SWIFT 2022 Series Owner's Manual

• When driving on steep hills, the vehicle
may begin to slow down and show a lack
of power. If this happens, you should
shift to a lower gear so that the engine
will again be operating in its higher
power range. Shift rapidly to prevent the
vehicle from losing momentum.
• When driving down a hill, the engine
should be used for braking by shifting to
the next lower gear.
WARNING
Do not hold the brake pedal down too
long or too often while going down a
steep or long hill. This could cause
the brakes to overheat, resulting in
reduced braking efficiency. Failure to
take this precaution could result in
loss of vehicle control.
NOTICE
When descending a downhill, Never
turn the ignition key to "LOCK" posi-
tion or press the engine switch to
change the ignition mode to LOCK
(OFF). Emission control system and
automatic transmission and CVT (if
equipped) damage may result.

Driving on slippery roads

On wet roads, you should drive at a lower
speed than you do on dry roads due to
possible slippage of tyres during braking.
When driving on icy, snow-covered or
muddy roads, reduce your speed and
avoid sudden acceleration, abrupt braking,
or sharp steering movements.
Snow chains
Snow chains should only be used if they
are needed to increase traction or are
required by law. Check that the chains you
use are the correct size for your vehicle's
tyres. Also check that there is enough
clearance between the fenders and the
chains as installed on the tyres.
Install the chains on the front tyres tightly,
according to the chain manufacturer's
instructions. Retighten the chains after
driving about 1.0 km (1/2 mile) if neces-
sary. With the chains installed, drive slowly.
NOTICE
60G089S • If you hear the chains hitting
against the vehicle body while driv-
ing, stop and tighten them.
• If your vehicle is equipped with full
wheel caps, remove the wheel caps
before installing the chains or the
wheel caps can be damaged by the
chain bands.
DRIVING TIPS
4-4