Tilt / Telescoping (If Equipped) Steering Lock Lever - Suzuki NEXA FRONX Owner's Manual & Service Booklet

FOR SAFE DRIVING
WARNING
• If you drive the vehicle with the
head restraint removed, a passen-
ger's backward tilting cannot be
prevented in a collision from the
backward and the impact to a pas-
senger's head cannot be reduced
in a sudden braking or a collision.
This may cause severe injury.
Never drive the vehicle with the
head restraints removed.
• If the head restraint is installed
back to front or it is not installed
securely, the head restraint may
not provide the best performance
in case of emergency, resulting in
severe injury.
If the head restraint is installed
back to front, you cannot adjust the
height and install it securely.
Make sure to install the head
restraint securely in the right direc-
tion.
• Being distracted by head restraint
adjustment could lead to an acci-
dent.
Do not attempt to adjust the head
restraint while driving.
2-7
NOTE:
It may be necessary to recline the seat-
back to provide enough overhead clear-
ance to remove the head restraint.
55T020190
To raise the front head restraint, pull
upward the head restraint until it clicks. To
lower the head restraint, push down the
head restraint while holding in the lock but-
ton (1). If a head restraint must be
removed (for cleaning, replacement, etc.),
push in the lock button (1) and pull the
head restraint all the way out.
Tilt / Telescoping (if equipped)
Steering Lock Lever
(1)
(1)
(2)
(1) LOCK
(2) UNLOCK
The lock lever is located under the steering
column. To adjust the steering wheel height:
1) Push down the lock lever to unlock the
steering column.
2) Adjust the steering wheel to the desired
height and fore-aft position and lock the
steering column by pulling up the lock
lever.
3) Try moving the steering wheel up and
down back and forth to check that it is
securely locked in position.
WARNING
Never attempt to adjust the steering
wheel while the vehicle is moving or
you could lose control of the vehicle.
55TB0201
55TH0-74E