Adjustment
[Adjustment standard]
Start test mode, pass the schappe spun thread #60 through tension plate, tension disk,and plate assy., and pull it by
tension gauge, then adjust tension must be in 0.33 to 0.41N (34 to 42g).
[Adjustment procedure]
1. Remove the front thread guard cover.
2. Start the test mode.
3. Raise the presser foot lever.
4. Pass the schappe spun thread #60 through the thread guide, tension plate, tension disk and plate assy. in this order.
5. Lower the presser foot lever.
6. Pull thread by tension gauge, and turn the thread tension adjusting screw, and adjust the tension to 0.38 to 0.48N
(39 to 49g).
7. Apply a small amount of thread locker to thread tension adjusting screw.
XC2276001
Upper thread tension
Tension gauge (1.0N)
Tension disk
Plate assy.
0.38 - 0.48N (39 - 49g)
26
Tension plate
Thread guide
Thread tension
adjusting screw
4 - 11