Baby Lock Ellisimo BLSO Service Manual page 26

Adjustment
6. Through thread inside thread guide wire, then tie thread at the point A (thread take up spring).
Pull thread to above with the tension gauge, and check tension when pulling it to the thread guide wire.
7. Keep up thread catching case A protrusion, and turn thread catching case B (M5;8mm,wrench) clockwise for
adjusting tension (0.15 to 0.19N ; 15 to 19g).
*Key point
• When adjust tension, turn the thread catching case B "clockwise" (turning clockwise tension loose).
• In case tension is less than 0.15N (15g), go back procedure #4, and adjust it again.
8. Secure the thread catching case B with the pan head screw (S/P washer, M3x18 DA). (tightening torque: 0.29 to
0.49 N·m)
0.15 - 0.19N (15 - 19g)
Thread guide wire
Thread take up spring
<To next page>
Thread take up spring tension
Thread catching case B
(M5;8mm,wrench)
Thread catching case A
Thread
A
Protrusion of
the thread catching case A
Thread catching case B
28
Thread
Thread catching case B
Pan head screw
(S/P washer, M3x18 DA)
4 - 43