Baby Lock Ellisimo BLSO Service Manual page 17

Test Mode
With front cover
1. How to start test mode
Turn on the power while pressing the
mode starts (test mode screen is displayed).
2. Contents of test mode
Test mode
No.
01 Serial Numbers/Product ID
02 Fabric Thickness Setting/PF-PM Adjust
03 Pattern Adjustment
04 3-Point Needle Drop
06 Feed Dog Position
07 Presser Foot Height
10 Lower Thread
11 Upper Thread
12 Upper Thread 1
13 Forward and Reverse Feed
Start Test mode and Contents
(Start/Stop button) and the
Mode
Serial number/Product ID and software version are
displayed.
Adjust the fabric thickness setting / Knee lifter
position.
Test pattern is sewn, and set up the correction value
of the vertical and horizontal.
Change needle position (left, center, right)
Feed dog is moves to front/center/left/right.
Presser foot height and AD value are displayed.
Check the operation of the Lower thread detection
sensor.
(+.+: has lower thread, 0.0: empty lower thread)
* Turn the pulley by hand and shows 0.0 (lower
Check operation of upper thread detection sensor.
(+.+: has upper thread, 0.0: empty upper thread)
* Pulling up thread and move thread take up spring,
Disable detection function of upper thread/lower
thread and needle plate A/B.
(Effective once when turning on at the next time.)
Sewing 100 forward stitches (left base line), and 100
reverse stitches (right base line).
19
(Reverse stich button), then test
Contents of test mode
thread empty), then check the operation of sensor.
then check the operation of sensor.
Ref.
page
-
4-20
/4-21
4-26
4-13
4-23
-
-
-
-
4-24
4 - 3