Baby Lock Ellisimo BLSO Service Manual page 58

Adjustment
11. Press the button image processing result it displayed. (Fig. 7)
*Key point
• "O" is success, "X" is no good.
• Check needle drop point aligns with red circle (visual check).
• When the "X" is displayed on the screen, press the
button, and then start again from the procedure 5.
12. Press the (Needle position button), and raise the needle
up.
13. Remove the paper, and then remove the needle.
14. Press the button, and then image processing result is
displayed.
*Key point
• "O" is success, "X" is no good.
• In case "O" is displayed, the calibration processing is
successful. (Fig. 8)
Press the
selection screen.
• In case "X" is displayed, the calibration processing is failure.
(Fig. 9)
Press the
procedure 5.
When it fails again, check that the needle drop is good or
not.
<To next page>
Fig. 8 (Success)
4 - 38
Camera calibration
button, and then return the test mode
button, and then start again from the
Needle drop point
Fig. 9 (No good)
60
Fig. 7 (Success)