Baby Lock Ellisimo BLSO Service Manual page 43

Adjustment
[Adjustment standard]
When the feed dog is in highest position, feed dog height from needle plate A surface is 0.9 to 1.1mm. Feed dog
parallel with needle plate A.
[Adjustment procedure]
1. Remove the needle plate B, presser foot and needle.
2. Turn the pulley by hand to raise the feed dog to its highest position.
3. Turn the socket set screw (FT, M4x10) and adjust the back tooth of the feed dog is 0.9 to 1.1mm from needle plate
A surface. (Fig. 1)
4. Loose the socket bolt (M3x8), next to the feed adjuster. (Fig. 2)
5. Turn the socket set screw (FT, M4x10), adjust feed dog parallel with needle plate A. (Fig. 3)
6. Tighten the socket bolt (M3x8), next to the feed adjuster. (Fig. 2)
*Key point
• When adjusting the feed dog height, use the feed dog height gauge.
XC2278001
Fig. 1
Socket bolt (M3x8)
Fig. 3
4 - 22
Feed dog height and parallelism
Socket set screw
(FT, M4x10)
Fig. 2
Socket set screw
(FT, M4x10)
1.5mm
Feed dog height gauge
Feed dog highest position
Needle plate A
surface
A (10 : 1)
A
17.2mm
20.2mm
45
0.9 - 1.1mm
Feed dog
1.5mm
height gauge