Adjustment
[Adjustment standard]
In the test mode "02", set the cloth pressure: 0mm and 3mm.
[Adjustment procedure]
1. Attach the J presser foot.
2. Start the test mode, and then select the "02" (Fabric thickness setting / PF PM Adjust mode).
3. Turn the pulley by hand down the feed dog lower than the needle plate A.
4. Lower the presser foot lever, and press the
5. Raise the presser foot lever, and insert the 3mm gauge.
6. Lower the presser foot lever, and press the
7. Remove the 3mm gauge, and lower the presser foot lever.
8. Press the
button of the "PF PM Adjust" on the screen.
3mm
4 - 20
Cloth pressure setting
button on the screen.
button on the screen.
J foot
43