Table of Contents
Advertisement
3.Programming Setpoints
Program High and Low setpoints for easy Go/No Go testing.
ON/OFF
1. Press
2. Press and hold the
Program Menu.
3. Press the up or down arrows
on the keypad to highlight
High Low Setpoints, then
press the right arrow key.
4. When High appears press the
right arrow key to set the
High setpoint.
5. Press the up or down keys to
change the high setpoint and
MENU
press
return to the High Low
Setpoints.
6. Press the down arrow to highlight Low and then press the right
arrow key.
7. Press the up/down arrow keys to change the low setpoint and
MENU
press
8. Press the left arrow key until the door icon
MENU
and hold
key and when 'Exit Menu' appears, press
For example, if High and Low setpoints
have been programmed and 5 lbf-in is set
as Low and 10 lbf-in as High, the
ORANGE LED lights for measurements
less than 5 lbf-in (–NG). GREEN lights
between 5–10 lbf-in (OK) and RED lights
over 10 lbf-in (+NG). Setpoint output is
available through the Communications
port (see page 14).
page 8
to turn on the gauge.
MENU
key two seconds to enter the
to save and
to save.
two seconds to exit. Or press the left arrow
(optional)
Program Menu
Date and Time
#
High Low Setpoints
Peak Functions
High Low Setpoints
<
High
>
Low
High
{
1 0 . 0
<Back
}
Enter@
#
appears, then press
MENU
>
High Low Setpoints
High
<
Low
>
Low
{
5 . 0
<Back
}
Enter@
to exit.
Advertisement
Table of Contents
