Table of Contents
Advertisement
OPERATION
6
1.Programming
Select unit and set the high/low setpoints if required, using the
steps on pages 6-8.
2.Measurement Mode
Real Time Measurement
ON/OFF
Press
enters real time mode and displays transient torque values.
Peak Measurement
ON/OFF
Press
peak measurements. In Multi display mode 'P' is displayed and in
Single display mode 'Peak' is displayed. Peak torque values do not
change until a higher value is measured. Press
return to real time.
'Or Peak' is the factory default and captures either clockwise
peak or tension measured during a test.
'And Peak' captures both clockwise peak and counterclock-
wise peak (See page 34 for programming instructions).
When 'And Peak' is programmed press
played. Press
'+P' displays the clockwise peak captured during a test; press
PEAK
to display the counterclockwise peak.
'–P' displays the counterclockwise peak captured during a test;
PEAK
press
3.Tare and Zero
'All Reset' is the factory default that tares
and zeroes the display. Press
clamping the sample in position to zero the
display and tare any preload. After clamping
do not tare.
If you need to zero without tare see page 41
'Peak Only'.
to turn on the gauge. The gauge automatically
to turn on the gauge. Press
PEAK
again and '–P' is displayed.
to display the clockwise peak.
PEAK
ZERO
before
PEAK
to capture
PEAK
again to
and '+P' is dis-
When measuring, hold the torque
sensor inline not at an angle.
page 9
Advertisement
Table of Contents
