High Low Setpoints; Peak Functions - Imada HTGS-4 Instruction Manual

REFERENCE SECTION — PROGRAM MENU
12

High Low Setpoints

1
High/Low setpoints enable Go/No Go tests. Orange
LED lights for values under the low setpoint (–NG),
green lights for values within low and high (OK),
and red lights for values over high (+NG). See page 8.
1. Turn ON the gauge, then press and hold
enter the Program Menu. High/Low Setpoints, is highlighted, press
the right arrow key to select.
2. High is highlighted; press the right arrow key to select.
3. Press the up/down arrow keys to change the High value and
MENU
press
4. Press the down arrow key to highlight Low, then press the right
arrow key to select.
5. Press the up/down arrow keys to change the Low value and
MENU
press
6. Press the left arrow key until the door icon
MENU
and hold
key and when 'Exit Menu' appears, press

Peak Functions

2
[and][or] Peak Factory Default='Or'
'Or Peak' captures clockwise OR counterclock-
wise peak.
'And Peak' captures both clockwise AND counterclockwise peaks. See
page 9 for instructions.
1. Turn ON the gauge. Press and hold
the Program Menu. Press down arrow key, to highlight Peak
Functions then press the right arrow key, to select.
2. [and][or] Peak is highlighted; press the right arrow key to select.
3. Press the up/down arrow keys to select and press
input your selection.
4. Press the left arrow key until the door icon
MENU
and hold
key and when 'Exit Menu' appears, press
page 34
to input your selection.
to input your selection.
two seconds to exit. Or press the left arrow
two seconds to exit. Or press the left arrow
MENU
two seconds to
#
appears, then press
MENU
MENU
two seconds to enter
#
appears, then press
MENU
1/6
Program Menu
Date and Time
# High Low Setpoints >
Peak Functions
to exit.
Program Menu
High Low Setpoints
# Peak Functions >
Internal Memory
MENU
to
to exit.