Table of Contents
Advertisement
PREPARATION
4
1.Connecting the Sensor
1. To connect the remote sensor to the
display unit, rotate the connector to
match the groove with the key, then
push it in until positive connection is
made.
2. To disconnect, hold the ribbed cover of
the connector and pull out.
DO NOT TWIST OR PULL THE CABLE!
2.Charging the Ni-MH Battery
Power shuts off after 10 minutes of non-use. Recharge the battery
when the icon shows a single bar
hours. When fully charged the
Auto shut off is bypassed when used with the AC adapter/charger.
The battery also charges when connected to a computer USB port.
ON/OFF
1. Push
2. Only use IMADA AC adapter/charger (ADW6010) with the proper
115VAC or 230VAC plug adapter. Plug into the correct AC output.
Turn ON the gauge. The display flashes until the battery is charged.
to turn off power.
ROTATE CONNECTOR TO MATCH THE GROOVE
WITH THE KEY AND PUSH IN.
HOLD RIBBED COVER AND PULL OUT. DO NOT
TWIST OR PULL CABLE!
. A full charge takes about two
icon appears and charging stops.
page 5
Advertisement
Table of Contents
