Removing The Protective Covering From The Drive Module Air Outlet; Miscellaneous; Input Power Cable Entry From Top; Attaching The Drive Module To A Mounting Plate Or Wall - ABB ACS580-04 Hardware Manual

Installation example of drive module with IP20 shrouds (option +B051) 119
Removing the protective covering from the drive module
air outlet
WARNING!
Remove the protective covering from the top of the drive module after the
installation. If the covering is not removed, the cooling air cannot flow freely
through the module and the drive will overheat.

Miscellaneous

Input power cable entry from top

￭
If you run the input cables from top to the drive module, drill the entry holes to the
top clear plastic shroud.

Attaching the drive module to a mounting plate or wall

￭
Use the support bracket 3AUA0000096082 (included in the assembly kit
3AXD50000453900) if you attach the drive module directly to a mounting plate or
wall. The support bracket prevents the drive module screws from chafing against the
plate.
M4×12 Torx