Installation; Unpacking And Checking The Delivery; Removing The Control Panel From The Drive - ABB CDPI-01 User Manual

Installation

Unpacking and checking the delivery

1. Open the option package.
2. Make sure that the package contains:
•
CDPI-01 communication adapter module
•
this manual.
3. Make sure that there are no signs of damage.

Removing the control panel from the drive

The communication adapter module is installed in the same slot as
the control panel. If a control panel is attached to the drive, remove
the control panel first as follows.
Note: If the drive is in local control and you do not stop the drive
before you remove the control panel, the motor will stop and the
drive will trip to a fault.
1. If the drive is running, stop the drive.
2. Release the control panel by pressing the clip at the upper end
of the panel.
3. Pull the upper end of the control panel out of the slot in the
drive.
CDPI-01 communication adapter module 9