Mechanical Installation; Necessary Tools; Unpacking And Examining The Delivery; Installing The Module - ABB ACS580-04 Hardware Manual

Mechanical installation

Necessary tools

￭
• Screwdriver and a set of suitable bits.

Unpacking and examining the delivery

￭
1. Open the option package. Make sure that the package contains:
• the option module
• a mounting screw.
2. Make sure that there are no signs of damage.

Installing the module

￭
See section Installing option modules (page

Electrical installation

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section
before you start the work.
Necessary tools
￭
• Screwdriver and a set of suitable bits.

Wiring

￭
Connect the external control cables to the applicable module terminals. Ground the
outer shield of the control cables at the cabinet entry.

Start-up

Setting the parameters

￭
1. Power up the drive.
2. If no warning is shown,
• make sure that the value of both parameters 15.01 Extension module type
and 15.02 Detected extension module is CHDI-01.
If warning the A7AB Extension I/O configuration failure is shown,
• make sure that the value of parameter 15.02 is CHDI-01.
• set parameter 15.01 value to CHDI-01.
You can now see the parameters of the extension module in parameter group 15
I/O extension module.
3. Set the parameters of the extension module to applicable values.

Parameter setting example for relay output

This example shows how make the relay output RO4 of the extension module indicate
the reverse direction of rotation of the motor with a one-second delay.
CHDI-01 115/230 V digital input extension module 263
110).
Electrical safety precautions (page 21)