Required Tools; Overall Flowchart Of The Installation Process; Installing The Drive Module Into The Enclosure - ABB ACS580-04 Hardware Manual

114 Installation example of drive module with IP20 shrouds (option +B051)
DK 7967.000
(one set = four pieces)
VX 8617.030
TS 4396.500
SK 3243.200
Customer-made parts (not ABB or Rittal parts)
Air baffles

Required tools

• Set of screw drivers (Torx and Pozidriv)
• Set of metric magnetic-end hexagon sockets
• Torque wrench
• Step drill bit for drilling the holes in the clear plastic shroud for input power cables.

Overall flowchart of the installation process

Step Task
1 Install the Rittal parts, drive bottom guide
plate and loose drive options in the drive
module cubicle.
2 Install the auxiliary components (such as
mounting plates, air baffles, switches, busbars
etc.).
Attach the drive module to the enclosure
Connect the power cables and install the clear
plastic shrouds to the drive module.
3 Connect the control cables.
4 Install the remaining parts, for example, cab-
inet doors, side plates, etc.

Installing the drive module into the enclosure

For illustrations on how to install the drive module with IP20 shrouds into a enclosure,
refer to:
• chapter Step-by-step drawings for an installation example of a drive module with
the +B051 option in a Rittal VX25 600 mm wide
• ACS580-04 drive modules (250 to 500 kW) quick installation guide
(3AXD50000823291
1 Spacers for roof plates.
5 Punched section with mounting flange, outer mounting level for
600 mm horizontal
Support rails
4 Air filter 323 mm × 323 mm. Remove the filter mats.
2 See section Preventing the recirculation of hot air (page
[Multilingual]).
For instructions, see
• Installing the drive module into the enclos-
ure (page 114)
• Installation drawings
• The component manufacturer's instruc-
tions
• Planning the cooling of the ACS580-
04 (page 55)
• Step-by-step drawings for an installation
example of a drive module with the +B051
option in a Rittal VX25 600 mm wide enclos-
ure (page 289)
• Connecting the power cables and installing
the shrouds (page 115)
• Connecting the control cables (page
• The component manufacturer's instruc-
tions.
• Installing the roof and door (Rittal
parts) (page 117)
enclosure, and
46).
107).