Table of Contents
Advertisement
[I-Picture Mode 1], [I-Picture Mode 2]
Sets the method for specifying the I-picture insertion interval for H.264 and H.265 to [Time] or [Frame].
Cannot be set for [Codec 3].
[Time]: Sets the I-picture insertion interval as a time.
[Frame]: Sets the I-picture insertion interval as a number of frames.
[I-Picture Interval 1], [I-Picture Interval 2]
Sets the I-picture insertion interval in units of seconds. Sets a value in the range 1 second to 5 seconds. The default
value is 1 second.
Cannot be set for [Codec 3].
[I-Picture Ratio 1], [I-Picture Ratio 2]
Sets the I-picture insertion interval for H.264 and H.265 as a number of frames in the range 15 to 300. The default value
is 300 frames.
Cannot be set for [Codec 3].
[Profile 1], [Profile 2]
Sets the H.264 or H.265 image codec profile.
[H.264]: Select [high], [main], or [baseline] profile.
[H.265]: Select [main] or [main10] profile. When two video codecs are enabled, only the [main] profile selection option is
available.
Image compression efficiency increases in the order of [high], [main], and [baseline]. Select a profile supported by your
system.
When [H.265] is set to [main10], operation is in [main10] when the HDMI output is YCrCb or [main] when the HDMI
output is RGB.
Cannot be set for [Codec 3].
[Bit Rate Compression Mode 1], [Bit Rate Compression Mode 2]
Select [CBR] or [VBR].
To maintain a constant bit rate, select [CBR]. To maintain image quality, select [VBR].
Cannot be set for [Codec 3].
Note
The frame rate and bit rate actually streamed may differ from the set values, depending on the picture size, shooting scene,
network environment, and other factors.
When [Stream] > [Stream Setting] > [Setting] is set to [SRT-Caller] or [SRT-Listener], [Bit Rate Compression Mode 1] is set to
[CBR] (fixed).
[Bit Rate 1], [Bit Rate 2]
You can set the bit rate per video stream when [Bit Rate Compression Mode] is set to [CBR]. Setting a high bit rate
allows you to stream high image quality video.
Cannot be set for [Codec 3].
[Quality 1], [Quality 2], [Quality 3]
Sets the image quality in the range 1 to 10. A value of 10 sets the highest image quality. The default value is 6.
For [Quality 1] and [Quality 2], you can set H.264 image quality by setting [Bit Rate Compression Mode] to [VBR] and
[Codec] to [H.264]. You can set H.265 image quality by setting [Bit Rate Compression Mode] to [VBR] and [Codec] to
[H.265].
5-041-957-11(1) Copyright 2022 Sony Corporation
250
Advertisement
Table of Contents
