Adjustable Parameters - TESTO 6448 Instruction Manual

5 Operation
Condition at delivery: Not locked.
When the instrument is locked,
display if an attempt is made to change the parameter values.
5.1.4.

Adjustable parameters

Representation
in display
SPx (SP1,
SP2)
rPx (rP1,
rP2)
ImPS
ImPR
32
Description
Switch point 1/2
Upper limit value at which the output changes its switch
status.
Only active if OU2
Return switch point 1/2
Lower limit value at which the output changes its switch
status.
rPx is always smaller than SPx. Values can only be
entered which are lower than SPx.
When the switch point is changed, the return switch point
changes with it (the interval between
remains constant). If the interval is larger than the new
switch point, then it is reduced automatically
the minimum setting value).
= Hno, Hnc, Fno
Output 1 as pulse output
Only active if OU1
Configuring quantity monitoring through pulse output
Select ImPR and set to YES.
Pulse repetition is active. Output 1 emits a counting pulse
each time the value set in
Configure the quantity monitoring using the preset
counter.
Select ImPR and set to NO.
Pulse repetition is not active. The output switches ON
when the value set in
switched until the counter is reset.

Setting the preset counter / pulse value (ImPS).
is shown briefly in the
= Hno, Hnc, Fno
rP2 is only active when
or Fnc.
= ImP.
ImPS is reached.
ImPS is reached. It remains
or Fnc.
SPx and rPx
(rPx is set to
OU2