Table of Contents
Advertisement
Changing further parameters:
Ending programming:
Set the display unit (Uni) before you set the values for the SPx,
rPx,
rors are avoided during the internal conversion into other units and
the exact values required are provided. Condition at delivery:
nm3h.
If no button is pressed for 15 seconds during the setting process,
the instrument returns to the run mode with unchanged values.
The instrument can be electronically locked so that unintentional
false entries are avoided: Press both programming buttons in run
mode until
To unlock, press the buttons until
Condition at delivery: Not locked.
When the instrument is locked,
play if an attempt is made to change the parameter values.
6.1.3.
Adjustable parameters
Representati-
on in display
SP1
SP2
rP1
rP2
ASP
and
AEP
parameters. In this way, rounding up/down er-
is displayed.
Description
Switch point 1/2
Upper limit value at which the output changes its switch
status.
SP 2
is only active when
Return switch point 1/2
Lower limit value at which the output changes its switch
status.
rPx
is always smaller than SPx. Values can only be en-
tered which are lower than SPx.
When the switch point is changed, the return switch point
changes with it (the interval between
mains constant). If the interval is larger than the new
switch point, then it is reduced automatically
the minimum setting value).
= Hno, Hnc,
Fno
Start again with step 1.
Wait for 15 seconds or
press
the current measurement
value appears again.
is displayed.
is shown briefly in the dis-
OU2
= Hno, Hnc,
rP2
is only active when
or Fnc.
6 Operation
[Mode/Enter]
until
Uni
Fno
or
Fnc.
SPx
and
rPx
re-
(rPx
is set to
OU2
31
=
Advertisement
Table of Contents
