2 x switching outputs
Both of the available OUT1and
PNP signal output (pulse).
Pin assignment on the instrument
Five-wire pin assignment (accessory)
If the optional connecting cable for electrical isolation is used
(Connecting cable, page 16), then the following assignments
apply.
Wire colour
Brown
Pink
White
Green
Black
The potential-free pulse output
cable as follows:
Line type
Length
Switching capacity
Max. switching voltage
Min. switching voltage
Switch contact
resistance
Insulation voltage
Protected against
polarity reversal
OUT2
outputs are each used as a
Assignment
+L (19 to 30 V DC) sensor supply
+ potential-free pulse output
(collector) OUT1
- potential-free pulse output (emitter)
OUT1
OUT2
0 V DC (GND)
OUT1
is specified for this connecting
LiYCY
5 m
500 mA
36 V
5 V
0.21 Ohm
5.3 kV
Yes
4 Initial operation
25