Table of Contents
Advertisement
The totaliser (consumption quantity counter) periodically (every
10 minutes) stores interim values as well as the amount of time
elapsed of the automatic reset. After a drop in voltage, this value is
available as the current status of the totaliser (the possible loss of
data can amount to a maximum of 10 minutes).
Display mode
Display of the parameters and set parameter values
The instrument is switched to display mode by pressing
[Mode/Enter]
briefly. Internally, it remains operational.
The set parameter values can be read independent of this:
•
The parameters are read through by pressing
briefly.
•
The corresponding parameter value is displayed for
approximately 15 seconds by pressing
a further 15 seconds, the instrument returns to run mode.
Programming mode
Setting the parameter values
The instrument is switched to programming mode if a parameter is
selected and the
[Set]
(the parameter value flashes, then is continuously increased).
Internally, the instrument also remains operational here.
It continues to carry out its monitoring functions with the existing
parameters until the alteration is completed.
You can change the parameter value using
pressing [Mode/Enter].
The instrument returns to measurement mode if no buttons are
pressed for 15 seconds afterwards.
button is pressed for longer than 5 seconds
5 Operation
[Mode/Enter]
[Set]
briefly. After
[Set]
and confirm by
29
Advertisement
Table of Contents
