Maserati Grecale 2023 Owner's Manual page 52

Understanding the Vehicle
step for the same remaining button. DO
NOT erase the channels.
Reprogramming a Single HomeLink
Button
To reprogramme a channel that has been
2
previously trained, follow these steps:
• Place the ignition device to ON position
without starting the engine.
• Press and hold the desired HomeLink
button.
• Without releasing the button proceed
with "Programming the hand-held
transmitters" from second step and
follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before 1995
• Turn the ignition device to ON position
without starting the engine.
• Place the hand-held transmitter 1 to
3 inches (5 to 30 cm) away from the
®
HomeLink button you wish to program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
50
NOTE:
The distance necessary between the
portable hand-held transmitter and the
®
®
HomeLink
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
®
• Press and hold the programmed
HomeLink
If the garage door opener/device
activates, programming is complete. To
program the remaining two HomeLink
buttons, repeat each step for each
remaining button. Do not erase the
channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to ON position
without starting the engine.
• Press and hold the desired HomeLink
button.
• Without releasing the button proceed
with "Programming the hand-held
transmitters" from second step and
follow all remaining steps.
Using HomeLink
®
system.
To operate, press and release the
programmed HomeLink
in the vehicle depends on the
®
button.
®
®
®
®
®
button.
Activation will now occur for the
programmed device (i.e., garage door
opener, gate operator, security system,
entry door lock, home/office lighting,
etc.). The hand-held transmitter of the
device may also be used at any time.
Security
It is advisable to erase all channels
before you sell or turn in your vehicle. To
erase the channels press and hold the
®
two outside HomeLink buttons (I and
III) until the warning light starts flashing
(after approximately 20 seconds).
®
The HomeLink Universal Transceiver is
disabled when the vehicle security alarm
is active ( : chapter "Vehicle Security
Alarm" in section "Safety").
Troubleshooting Tips
If you are having trouble while
®
programming HomeLink , here are some
of the most common solutions:
• Replace the battery in the original
hand-held transmitter.
• Press the LEARN button on the garage
door opener to complete the training
for a rolling code.
• Did you unplug the device for
programming and forgot to plug it back
in?
If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet at