Maserati Grecale 2023 Owner's Manual page 201

When the transmission is set in R
(Reverse) mode the top view and rear
view of the surrounding scenario will be
automatically displayed on MIA display.
Image will be displayed with active
guidelines, if activated in the setting list,
as long as vehicle remains in R (Reverse)
mode.
When vehicle is shifted into a different
gear, if the camera delay is activated on
the MIA screen, the image will remain
displayed for about 10 seconds unless
the vehicle speed exceeds 8 mph (13
km/h). If the transmission is shifted
in P (Park) mode, the surround view
screen will be immediately canceled and
the radio will return to the last-viewed
screen.
Instead, when the transmission is set in
P (Park), N (Neutral) or D (Drive) mode
it is possible to activate the system by
touching the "Surround View Camera"
soft-key in "Controls" menu of the
"Vehicle" or in the App page, if the
vehicle speed is below 8 mph (13 km/h);
otherwise the soft-key becomes grayed.
If manually activated in these ways, the
camera view will expire after 10 seconds
the vehicle speed exceeds 8 mph (13
km/h).
Once the "Surround View Camera"
screen is displayed, it is possible
to choose which images to display
according to 4 possible views.
Rear view and top view
Rear cross path view and top
view
Front cross path view and top
view
Front view and top view
In any gear shift mode, when "Surround
View Camera" screen is displayed, a
pop up message will appear in the upper
Driver Assistance Systems
part for 5 seconds to advise the driver to
check the surrounding scenario before
any maneuver.
With transmission in P (Park), N (Neutral)
or D (Drive) mode, the upper right corner
of the screen will show the "X" key:
touch it to go back to the previous
screen of MIA display.
The deactivation of the rear visualization
via "X" soft-key is not possible when the
transmission is in R (Reverse) mode.
Choose the most suitable view for
the situation and the maneuver you
are performing or going to perform,
by touching the soft-key present on
the left of the display: the edges of the
pressed button will highlight. The icon
will highlight and the type of selected
view will appear on each image.
In the top view, the vehicle is
represented as it is during the maneuver
(see example in the figure).
To display also the dynamic lines of the
trajectory you are setting, it is necessary
to set this function by accessing the
"Settings" menu on "Vehicle" page of
MIA, at "Camera" item, by using the
dynamic gridlines activation menu.
For further information, see "Functions
of Settings Menu on MIA" in section
"Dashboard Instruments and Controls".
6
199