Table of Contents
Advertisement
Understanding the Vehicle
Pairing Remote Keyless Entry
Transmitter to Seats Memory
Your key fob can be programmed to
recall one of three programmed memory
profiles by pressing the
2
the key fob. Using your wearable activity
key, the programmed memory profile will
be automatically recalled.
NOTE:
This function can be enabled or
disabled using the MIA system, refer to
"Functions of Setting Menu on MIA" in
section "Dashboard Instruments and
Controls" for further information.
To program your key fobs or your
wearable activity key, perform the
following actions:
•
Cycle the ignition device to ON
position.
•
Put the key fob or the wearable on
the spot inside the rear central tunnel
compartment, under the armrest.
•
Move the seat and/or the other
adjustable devices in the position that
you wish to memorize, or recall a
previously memorized profile, pressing
the corresponding memory "M1", "M2"
or "M3".
•
Press and release the desired memory
soft-key "M1", "M2" or "M3" for 3
seconds.
•
Press and release the
key fob.
22
•
A visual message will appear on the
instrument cluster display to confirm
the selection.
To check if the system has memorized
the correct profile, you can move the
button on
seat and press the
will move to the memorized position.
Memory Position Recall
NOTE:
The vehicle must be in P (Park) to
recall memory positions. If a recall is
attempted when the vehicle is not in P
(Park), a message will display in the
instrument cluster.
To recall the memory settings for driver,
press memory soft-key "M1", "M2" or
"M3" on the Comfort Display or the
button on the key fob linked to memory
position "M1", "M2" or "M3" with ignition
device in ON position.
A recall can be canceled by pressing
any of the icons (M1", "M2" or "M3")
during a recall. When a recall is canceled,
the driver seat, external side mirrors
and power tilt and telescopic steering
column stop moving.
A delay of at least one second will occur
before selecting a new recall.
Easy Entry/Exit Driver Seat
This function provides automatic driver
button on the
seat positioning to enhance driver
mobility when entering and exiting the
vehicle.
The distance the driver seat moves
depends on where you have the driver
seat positioned when you place the
ignition device to the STOP position.
button: the seat
•
When you cycle the ignition device to
the STOP position the driver seat:
-
will move about 60 mm (2.36 in)
rearward if the driver seat position is
greater than or equal to ca. 140 mm
(5.51 in) forward of the rear stop;
-
will move to a position of ca. 80 mm
(3.15 in) rearward of the rear stop if
the driver seat position is between
140 mm (5.51 in) and 80 mm (3.15 in)
forward of the rear stop.
•
The seat will return to its previously set
position when you place the ignition
device into the ON position.
•
The easy entry/exit function is disabled
when the driver seat position is less
than 80 mm (3.15 in) forward of the rear
stop. In this position, there would be no
benefit to the driver by moving the seat
for easy exit or easy entry.
Each stored memory setting will have an
associated easy entry/exit position.
NOTE:
The "Easy Entry/Exit" function can be
enabled or disabled using the MIA
system, refer to "Function of Settings
Advertisement
Chapters
Table of Contents
