Maserati Grecale 2023 Owner's Manual page 32

Understanding the Vehicle
2
Integrated External Rear-View Mirror
Lights
LED turn signals are integrated on the
support of the external rear-view mirrors.
The LED turn signal indicators flash
simultaneously with the corresponding
turn signal lights in the front and rear
of the vehicle. Turning on the hazard
warning lights will also activate these
LEDs.
All external mirrors are equipped with
approach and courtesy LEDs, lighting
30
up when the vehicle entry/exit lights
are activated. For further information,
see chapter "Illuminated Entry/Exit" in
section "Before Starting".
Automatic High Beam ( )
The Automatic High Beam headlight
control system provides increased
forward lighting at night by automating
high beam control through the use of the
forward-facing digital camera located
behind the rear-view mirror, which is
the same one used for example by the
Active Lane Management - ALM system
on vehicles with ADAS systems.
This camera detects the environmental
luminosity, the headlamps of oncoming
vehicles and the tail lamps of proceeding
vehicles in the front area.
In these cases system automatically
switches from high beams to low beams
until the approaching vehicle is out of
view.
Furthermore, using the maps, together
with the camera, the system is able to
detect the urban areas and the inhabited
centers and to turn off the high beams
when driving near of one of them.
The system will be active once passed
the speed of 21.7 mph (35 km/h). The
properly working for this system (if all
the other conditions are met) is ensured
between 15.5 mph (25 km/h) and 155
mph (250 km/h).
Activation Mode
To activate Automatic High Beam
function:
• Activate the "AUTO" button in the Light
menu on the Comfort Display.
• Touch the "Vehicle" soft-key on the
main category bar of the MIA display
and open the "Settings" menu.
• Choose the "Auto Dim High Beams"
function in the "Lights" submenu and
insert the check mark in the box to turn
on the function.
• To turn off the function delete the
check mark in the box.
• Shift the multifunction lever onward
.
NOTE:
All the previous steps must be
performed with the ignition device in ON
position
After these steps, the white indicator on
the left side of the cluster display comes
on.