Maserati Grecale 2023 Owner's Manual page 51

transmitter of the device that is being
programmed to the HomeLink
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
during the production phase. To erase
such codes:
• place the ignition device in ON position
without starting the engine;
• press and hold the two outside
®
HomeLink buttons (I and III) until the
warning light starts flashing (after
approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes should only
be performed when programming
®
HomeLink for the first time. Do not
perform this operation to program
additional buttons.
• If you have any problems, or require
assistance, please call toll-free
1 – 800 – 355 – 3515 or, on the Internet at
www.HomeLink.com for information or
assistance.
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
"LEARN" or "TRAIN" setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
®
system. normally used to open and close the
door.
The name and color of the button may
®
device vary by manufacturer.
• Place the ignition device to ON position
without starting the engine.
• Place the hand-held transmitter 1 to
3 inches (5 - 30 cm) away from the
®
HomeLink
• Simultaneously press the Homelink
button you want to program and the
hand-held transmitter button.
• Release immediately the Homelink
button you want to program.
• Continue holding the hand-held
transmitter button until the warning
light starts flashing quickly; then
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
NOTE:
The distance necessary between the
portable hand-held transmitter and the
®
HomeLink in the vehicle depends on the
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
button you wish to program.
®
®
®
system.
Understanding the Vehicle
Synchronising the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
programmed for a rolling code system,
it will be necessary to synchronise it to
ensure its correct operation.
• Locate the "LEARN" or "TRAINING"
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when
the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the next
step after the setting button has been
pressed.
• Return to the vehicle and press the
®
programmed HomeLink button for two
seconds and then release it.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
®
HomeLink buttons, repeat the same
®
has been
2
49