Maserati Grecale 2023 Owner's Manual page 204

Driver Assistance Systems
speed at 4 mph (4 km/h). In this stage,
the driver can modify the HDC set speed.
When the vehicle exceeds a defined
threshold of slope (8%), the
turns green and the current set speed
appears below it. Therefore, the vehicle
speed is increased or decreased until it
reaches the default value.
Setting
6
The set speed for HDC is selectable by
the driver, and can be adjusted by using
the brake pedal unit or the multifunction
control on steering wheel, which is the
same used to set the Cruise Control
(see "Cruise Control - CC" or "Adaptive
Cruise Control - ACC" in this section).
• If the driver brakes, the speed is
reduced and the HDC set speed is
updated according to the current
vehicle speed, up to 1 mph (2 km/h)
• If the driver accelerates without
exceeding the maximum limit value of
202
20 mph (40 km/h) the HDC set speed
does not change; when s/he releases
the accelerator pedal HDC reduces the
vehicle speed to the previous HDC set
light
speed. The set value appears under the
green light on the display.
Or:
• Push (SET -) multifunction switch or
press the brake pedal to decrease the
speed up to 1 mph (2 km/h). The set
value appears under the
on the cluster display.
• Push (SET +) multifunction switch to
increase speed until the required value
is displayed below the
on display.
green light
HDC Deactivation
HDC is deactivated by pressing the
HDC soft-key on the bottom bar of the
Comfort Display.
Driver Override
If the driver pushes the accelerator and
the vehicle speed exceeds the set
speed, the
• HDC will be deactivated but remain
available when driver pushes the
accelerator steadily, without exceeding
20 mph (40 km/h). A pop up message
and the
• When the vehicle speed exceeds 20
green light
mph (40 km/h) but is lower than 40
mph (50 km/h) this function turns to
stand-by mode, the
the set speed turns white. In this case,
to reset the function it is necessary to
reduce speed below 20 mph (40 km/h).
• While, if speed exceeds 40 mph (50
km/h), system will immediately disable
white light will stay on.
white light will stay on.
light with below