Leica AT500 User Manual page 50

4.3
Description
50
The AT500 supports the wireless topologies:
Access Point Mode: The AT500 serves as Access Point to allow multiple
•
clients to establish a connection. For example, to an application com-
puter, a remote control or multiple Absolute Tracker setups.
Connection to an external Access Point: The AT500 connects as client
•
to an external Access Point. For example, to a company network or as
a client to different Absolute Tracker in the same network.
24841_001
The setup is similar to the wired configuration. For the Application Processor,
install and configure the WLAN module.
☞ Refer to Tracker Pilot Reference Manual for detailed instructions
on setting up a WLAN connection.
☞ For certain countries with special regulations for operating wire-
less networks the WLAN module will be decommissioned by the
factory. The user of the product will not be able to activate the
WLAN module in this case. Please contact your local Hexagon
representative or distributor for further details on wireless net-
work regulations.
Application Processor
The Application Processor runs the application software. The application
software must be installed beforehand.
☞ Refer to the manual of the application software for further
details.
Operation