Table of Contents
Advertisement
Deskset Registration
The deskset must be registered to the base station in order to make and receive calls�
When you power up the deskset for the first time, it will attempt to auto-register to
the base station� Auto-registration will be successful only if you have set up the M500
configuration file with the deskset IPEI, or you have entered the IPEI on the Primary
base station's WebUI�
Auto-registering the deskset to the base station
1� Make sure the base station is connected to power and the network�
2�
If the deskset is displaying the following screen:
3�
If the deskset is displaying the following screen:
If registration is successful:
The deskset beeps and displays "Deskset
registered", and then displays the idle screen�
If registration fails:
The deskset displays "Registration failed"�
1� Press OK�
The deskset displays "Device not registered to base station�"
2� Press IPEI to display the phone's IPEI and
serial number� Give these numbers to your
phone administrator�
3� Press Back�
4� To manually register your deskset, follow
the steps in "Manually registering via the
LINK key on base station" on page 21 or "Manually registering via the
Web UI" on page 22�
a� Wait for the deskset to auto-register�
b� If the IPEI has not been set up in the
configuration file (provisioned), or the auto-
registration is taking too long, press Cancel�
a� Press Register� The deskset displays the
"Register via" menu�
b� Press
or
input, and press Select�
The deskset displays "Trying to auto-
register���"
c� Wait for the deskset to auto-register�
d� If auto-registration is taking too long, press
Cancel�
19
to scroll to Auto reg or IPEI
Advertisement
Table of Contents
