Base Station - Snom M58 User Manual

Manually registering via the LINK key on base station
1� Make sure the base station is connected to power and the network�
NOTE: If your phone system is a multi-cell environment, you can only register
the deskset to the Primary base station (as indicated by a steady green or slowly
flashing red
2� If the deskset is displaying the following screen:
3� On the "Device not registered to base station�" screen, press Register�
4� With LINK key on Base highlighted, press Select�
The handet displays the following screen:
5� Press and hold the LINK button on the base station for four seconds�
The (power) and
6� Press the # key on the deskset to begin registration�
The deskset displays "Registering��� Please Wait�"
If registration is successful:
The deskset beeps and displays "Deskset
Registered", and then displays the idle screen�
If registration fails:
The deskset beeps and displays "Registration
failed"�
a� Press OK�
The deskset displays "Device not registered to base station�"
b� Make sure the deskset is near the base station�
c� If your phone system is a multi-cell environment, make sure you are
registering to the Primary base station� The
steady green or slowly flashing red�
d� Try to register again; go to step 3�
SIP LED)�
a� Press Cancel�
b� Press OK�
(SIP) LEDs flash green�
The deskset displays "Registration failed"�
The deskset displays "Device not registered
to base station�"
21
SIP LED should be either