Activating The Wi-Fi Mode; Connecting To The Wireless Network - Yealink One Talk CP925 User Manual

Activating the Wi-Fi mode

You can activate the Wi-Fi mode to connect your phone to an available wireless network.
Procedure
1.
Go to More > Basic > Wi-Fi.
2.
Turn on Wi-Fi.
The phone scans the available wireless networks in your area.

Connecting to the wireless network

After you have activated the Wi-Fi mode, you can connect the phone to the wireless network.
Connecting to an available wireless network manually
When you enable the Wi-Fi mode, the phone is automatically connected to the saved wireless network, you can also connect it manually.
Before you begin
Get the password of the wireless network from your system administrator. Make sure that the Wi-Fi mode is activated.
Procedure
1.
Go to More > Basic > Wi-Fi.
2.
Tap the desired wireless network to connect.
3. Enter the password in the Password field.
4.
Select Save.
Connecting to the wireless network Using WPS
The Wi-Fi protected setup (WPS) provides simplified mechanisms to configure secure wireless networks which can automatically configure a
wireless network with a network name (SSID) and strong WPA data encryption and authentication.
There are two supported methods in the Wi-Fi protected setup:
•
Push Button Configuration (PBC): The user simply has to press the WPS key on both the phone and gate- way/router
to connect
•
Personal Identification Number (PIN): The user enters the PIN generated randomly by the phone on the gate- way/router to connect
Before you begin
Make sure that the Wi-Fi mode is activated.
Procedure
1.
Go to More > Basic > Wi-Fi.
2.
Do one of the following:
•
Select WPS to use the PBC method, then long press the WPS key on your gateway or router
–
Once the WPS setup has completed successfully, the phone screen will prompt "Connect Success"
•
Select WPS-PIN to use the PIN method, then log into your gateway or router's web interface, and configure it to search the
clients. For more information, refer to the documentation from the gateway or router manufacturer
–
Once WPS-PIN setup has completed successfully, the web interface of the gateway or router will prompt that the connection is
successful
Adding a wireless network manually
If SSID broadcast on your gateway or router is disabled, the wireless network might not appear in the scanning results. In that case, you must
manually add a wireless network. The phone can store up to 5 connected wireless networks.
Before you begin
User guide
47