Turning The Cpw25 On Or Off; Registering The Cpw25 - Yealink One Talk CP925 User Manual

1. Put the CPW25 on the charging cradle.
2.
Connect the charging cradle to the USB port on the phone using a USB cable.
During charging, the battery LED indicator on the CPW25 glows solid red. When the battery capacity reaches 100%, the battery LED indicator
on the CPW25 will glow solid green.
Note: If your system administrator disables the USB port of the phone, the phone cannot power to the USB port.

Turning the CPW25 On or Off

To use the CPW25 as the external audio input device, you need to turn the CPW25 on first.
Procedure
1.
You can do the following to turn on the CPW25:
•
Put the CPW25 on a charging cradle or connect to the charging cable, the CPW25 starts up automatically
•
If you do not charge the CPW25, long tap
The battery LED indicator glows green for one second and then goes out
2.
To turn off the CPW25, long tap
Note: When the battery is below 10%, the battery LED indicator flashes red, and it will automatically shut down after 10 minutes of standby;
when the low battery reaches 0%, it will automatically shut down.

Registering the CPW25

To ensure good voice quality of the calls on the phones, you can register CPW25 with the phone to use the CPW25 as the external audio input
device.
Procedure
1.
Go to More > MIC.
2.
Select OK when the phone prompts you that turning on the Bluetooth microphone will turn off Bluetooth.
3.
Select to search for CPW25.
4.
Turn on the CPW25.
The CPW25 will enter the registration mode automatically. And the mute LED indicator on the CPW25 fast
lashes yellow.
The CPW25 registers with the phone automatically. If the registration is successful, the mute LED indicator on the CPW25 goes out and
phone screen prompts the CPW25 information: battery, work time and standby time.
on the CPW25 for 3 seconds
on the CPW25 until the battery LED indicator glows red for 3 seconds and then goes out.
User guide
40