System Operation: Turning The System On - Lightspeed REDCAT User Manual

SYSTEM OPERATION
TURNING THE SYSTEM ON
CH A
CH B
POWER
3. Turn on the LightMic and set the operating
channel to "A." This microphone will be
designated as the "Teacher Mic."
4. the volume up or down as needed. At proper
Adjust
volume level, you will just barely be able to hear your
own voice. Remember! Classroom Amplification Technology
is a low-volume system providing clarity of speech and even
sound distribution throughout the learning environment.
Having the volume set too high will result in feedback
and listener fatigue.
EQUALIZER
250 400 600 1K 1K6 2K5
6. If a second student pass-around microphone
was purchased with system, repeat steps
3-4 but set the operating channel to "B."
(If a HM-70 was purchased, see page 16.)
1. Turn the REDCAT on. The LED on the power switch will glow.
2. Slip the LT-71 LightMic with
lanyard around the neck
and position the top of the
microphone just below the
collarbone. Note: Positioning
of the LightMic is critical for
proper volume adjustment.
>>
DC IN
24VDC
+
>>
4K 6K3
R E D C A T U s e r M a n u a l
>>
–
5. Once initial volume level is set,
walk around the room and listen for
audio dropout and overall audio
+10
quality. Fine-tuning the audio is
accomplished by making minor
0
adjustments to the 8-Band Graphic
Equalizer on the back panel of the
-10
receiver/amplifier.
>>
LT-71
A CH B
OFF
ON
A CH B
OFF
ON
REDCAT User Manual | 8
CH A
CH B
POWER