Getting Started; Software Requirements - ST STM32F0 Series Application Note

Getting started

2 Getting started
This section describes the requirements and procedures needed to start using the clock
tool.
2.1

Software requirements

To use the clock tool with Windows
as Windows XP, Vista or Windows 7 must be installed on the PC with at least
256 Mbytes of RAM.
Before starting to use the clock tool, make sure that Microsoft
machine and then follow these steps:
● Download the latest version of the clock tool for the STM32F0xx product from
www.st.com.
●
Enable macros and ActiveX
®
Excel 1997-2003 version
1. Click Tools in the menu bar.
2. Click Macro.
3. Click Security.
4. Click Low (not recommended).
Note: If ActiveX controls are not enabled, a warning message is displayed asking you to enable
ActiveX. In this case, you should click "OK" to enable it.
Excel 2007 version
1. Click the Microsoft Office button and then click Excel options.
2. Click Trust Center, click Trust center settings, and then click Macro settings.
3. Click Enable all macros (not recommended, potentially dangerous code can run).
4. Click Trust Center, click Trust center settings, and then click ActiveX settings.
5. Click Enable all controls without restrictions and without prompting (not
recommended; potentiality dangerous controls can run).
6. Click OK.
Note: For more information about how to enable macros and ActiveX controls please refer to the
Microsoft Office website.
6/17
®
operating system, a recent version of Windows, such
®
controls:
Doc ID 022837 Rev 1
®
Office is installed on your
AN4055