Table of Contents
Advertisement
Data Setting and Monitoring
Operation Key Functions
Name
Return Key
When beginning a setting change, press the Return Key, the Up Key, or the Down Key. The MODE
number will then blink. Each time the Return Key is pressed, the set value that is blinking will be
entered and the next item to be set will start blinking.
Up Key
When beginning a setting change, press the Return Key, the Up Key, or the Down Key. The MODE
number will then blink. Press the Up Key to increment the number that is blinking. When making a
DATA setting, press the Up Key continually to successively increment the number.
Down Key
When beginning a setting change, press the Return Key, the Up Key, or the Down Key. The MODE
number will then blink. Press the Up Key to decrement the number that is blinking. When making a
DATA setting, press the Up Key continually to successively decrement the number.
Reverse Key
When the Reverse Key is pressed, the setting item that is currently blinking will stop and the previous
item will start blinking. To finish making settings in a given mode, use the Reverse Key to return to the
blinking MODE display and then press the Reverse Key again. The blinking display will then stay lit and
the settings will be complete.
Clear Key
When the Clear Key is pressed, all data below the blinking item will be cleared. For example, if "1" is
blinking for BK, all of the data for bank no. 1 will be cleared. When the Clear Key is pressed once, the
item that is to be cleared will start blinking. If the Clear Key is then pressed a second time, the data will
be cleared. To cancel the clear, press any Key other the Clear Key before pressing the Clear Key the
second time. This function does not exist in the adjustment operation mode (mode 6). Press the Clear
Key to clear an error display.
3-3
Data Setting and Monitoring
Setting Items
MODE
Setting
item
3 (Cam data
BK
setting)
6 (Adjustment
operation)
CAM
STEP
ON
OFF
4 (Protect set-
BK
ting)
CAM
DATA
5 (Number of
DATA
revolutions
required for a
single
process)
Name
Bank no.
Cam output no.
Step no.
ON angle
OFF angle
Bank no.
Cam output no.
Not protected
Protected
Decimal point position
Data
For Modes 3, 4, and 5, set the RUN/PRG selector to PRG.
Mode 4 is valid only when pin 2 of the rear panel DIP switch is OFF (i.e., when
protection is permitted).
Mode 6 is available only when pin 3 of the rear panel DIP switch is OFF (i.e.,
when adjustment operation is permitted). For Mode 6, set the RUN/PRG
selector to RUN.
Function
Setting range
1 to 8
In Mode 6, the setting (i.e., the number of the bank to be
executed) is made from the C200H user's program or a
peripheral device.
1 to 48
1 to 16:
internal/external cam output
17 to 48:
Internal cam output
1 to 7
0 to 359
1 to 8
1 to 48
1 to 16:
internal/external cam output
17 to 48:
Internal cam output
"
"
"+- "
2 digits to right of decimal
1 digit to right of decimal
0 digits to right of decimal
0.01 to 9.99
0.1 to 99.9
1 to 999
Section 3-3
Set the number of resolver
revolutions required for a sin-
gle process cycle.
17
Advertisement
Chapters
Table of Contents
