Table of Contents
Advertisement
Maintenance Summary - 8 Years
J005
- Note on replacing the window pane or removing the design pane
Orientation
Maintenance Instructions
G300.2 G320.2 G400.2 G420 G500.2 G520
DIE147EN - 17.08.2022
The instructions described in this point only serve as information for
the subsequent maintenance activity "replace window pane" of the
respective machines.
If the window pane is damaged, it must be replaced. This is
necessary regardless of the extent of damage. Even with minimal
damage, the impact resistance of the pane can no longer be
guaranteed.
For safety reasons, it is recommended to obtain the window pane
directly from the machine manufacturer or its country representative.
The window pane consists of three panes. the inner pane of tempered glass, the
central pane of polycarbonate, and the outer pane also made of polycarbonate. The
inner pane is relatively resistant. It can be cleaned with any commercially available
cleaning agents. Only the center pane is essential for the impact resistance of the
window pane. The polycarbonate panes are subject to natural aging and must be
replaced at regular intervals.
Example: G200.2 Work area door 01 1
a
Outer pane (design pane made of PMMA – polymethyl methacrylate)
m
Center pane (polycarbonate)
i
Inner pane (glass)
s
Silicone gasket
Depending on the machine type, it may be necessary to remove a handle attached
here before dismantling the design disks.
137
Advertisement
Table of Contents
