Magtek DynaProx Installation And Operation Manual page 39

4 - Installation
4. Assembly is complete. Additionally, you can secure the base plate to almost any surface using (2)
additional screws, not included.
Securing DynaProx Stand to Surface
Follow Steps 1 through 2, then –
a. Place baseplate on the location where you want to secure the device. Trace the baseplate and mark the
two screw set locations (Drawn Outline). Remove the baseplate and drill down through the surface,
checking to make certain everything is clear beneath.
b. Attach the baseplate to the stand body following step 3. Then align on the surface to the tracing.
c. Using (2) M4 x 0.7mm thread pitch (not included) screws, screw up through the pre-drilled holes to the
baseplate. Screws should be long enough to go through the surface and no more than 0.25" into the stand
body.
DynaProx| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Page 39 of 57 (D998200490-11)