Connecting To A Host; About Connecting To A Host; How To Connect Dynaprox To A Host Via Usb - Magtek DynaProx Installation And Operation Manual

4 - Installation
4.3

Connecting to a Host

4.3.1 About Connecting to a Host

The following sections provide steps for connecting DynaProx to a host via the various available physical
connection types.

4.3.2 How to Connect DynaProx to a Host via USB

To connect DynaProx products to a USB host using the USB-C port, follow these steps (for reference see
Figure 4-1 and section 1.4 About DynaProx Components):For best results, use the cable that is included
with the device or another cable from Table 1-2 - DynaProx Accessories on page 19. These cables are
designed specifically for DynaProx products and include ferrite shielding at both ends of the cable to
reduce emissions and interference. If the solution design requires an alternate cable, contact MagTek for
assistance with ferrite selection and placement, and with connector overmold design.
1) Connect the USB-C end of the cable to DynaProx.
2) Connect the other end of the USB cable to the host's USB port.
3) As soon as the device starts receiving power through USB, it automatically powers on.
4) If the specific device serial number you are connecting has not been connected to the host before,
Windows system tray on the host reports it is
(approximately 30 seconds later depending on the host), Windows reports
DynaProx| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Figure 4-1 - Connecting to a USB Host
Setting up a device
Page 25 of 57 (D998200490-11)
. When installation is complete
Device is ready
, and the