6.2. SETUP MODE DESCRIPTION
The SETUP function can be accessed on the programme selection switch (see par. DATE AND TIME
SETUP).
Note: Below, in brackets, are the numbers used in the picture to identify the controls.
Procedure for accessing appliance's SETUP menu:
Press the ON/OFF button (3) to switch on the machine (If any alarm appears on the display at this
•
stage, ignore it).
Turn the PROGRAMME SELECTION SWITCH (1) to go to the SETUP position required (see the
•
description of programmable parameters below).
Press the DOOR OPEN BUTTON (6) for 4 seconds to enter the setup function Wait for the dual
•
beep as confirmation.
To increase a value press "TEMPERATURE VIEWING" (5) parameter must only be viewed and not
•
changed.
To decrease a value press START/PAUSE" (4) Do not use this button if the parameter must only be
•
viewed and not changed.
TO END PROGRAMMING, press the DOOR OPENING (6) button and keep it pressed for 4
•
seconds. The new settings are now saved.
IF YOU WISH TO EXIT THE SETUP MODE WITHOUT SAVING the parameters you may have
•
changed, do not press the DOOR OPENING (6) button, but turn off the machine using the ON/OFF
button (3).
Rev. 00
GW2045 – GW1060 Manual
Pag. 20 di 43