Table of Contents
Advertisement
Here are the steps which the installer must follow in order to flash the hood-pin switch:
1. Press and hold the hood-pin switch for 4
seconds.
2. Release the hood-pin switch.
3. While the parking lights are
the hood-pin switch once more.
4. Release
the
Caution! If you press down and release the
hood-pin switch too many times, you will
enter
diagnostic
programming mode.
5. You now have 20 sec. to select one of the
sub-menus.
Once the module has entered programming mode, you will have a selection of many
different sub-menus, which will be described later in this guide:
a. Transmitter Programming ..................................... p.14
b. Programming Options ........................................... p.16
c. Honk/Horn Timing (if available)............................. p.19
d. Tach Programming ............................................... p.17
Remember:
Once the Parking Lights are
a sub-menu. If you do not select a sub-menu within 20 seconds, the Remote
Car Starter will exit Programming Mode and you will have to flash the Hood
Pin switch once again.
The Programming Assistance Button
(A.k.a. the PAB.) Mounted on the Remote
Car Starter, this button can be used from
within the vehicle instead of the Hood Pin
switch in the Engine compartment. This will
spare the installer the trouble of accessing
the Hood Pin switch in the Engine
compartment.
Caution
The Hood Pin switch must be installed and connected in order for the
Programming Assistance Button to function. The button will work only
when the Hood is up.
AS-2360TW Installation Guide
The installer ...
, press down
ON
hood-pin
switch
mode
rather
Table 1: Flashing the hood-pin switch
(solid), you have up to 20 seconds to select
ON
The module ...
The parking lights will turn
again.
The parking lights will stay
for 20 seconds
than
.
ON
ON
P. 13
Advertisement
Table of Contents
