Horn Honk Timing; Tach Programming; About Tach Programming - Autostart AS-2360 TW Installation Manual

Manual transmissi on remote starter
Hide thumbs Also See for AS-2360 TW:
Table of Contents

Advertisement

Example: If the multi-level features were set to option 3, the setup would be as follows:
The "Basic features" are now programmed as level 3 and therefore:
To access the aux.2 feature, the user needs to press on the
followed by the
To access the status request feature, the user needs to press on the
(3) times followed by the
To access cold weather mode, the user needs to press on the
times followed by the

Horn Honk Timing

Follow these steps to program Horn Confirmation:
1.
Ensure that the Hood is up and that the Ignition is
• Hold the Hood Pin-switch down for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push and release the
Pin-switch again. The Parking Lights will stay on for up to 20 seconds.
2.
Press and hold the Brake Pedal, then simultaneously press the
buttons on the Transmitter – the Horn will honk 5 times.
3.
Release the Brake Pedal.
4.
To change the timing:
a. To increase the Horn pulse by 3 ms, press the
b. To decrease the pulse by 3 ms, press the
c. To increase the pulse by 10 ms, press the
d. To decrease the pulse by 10 ms, press the
5.
To save the new settings: press
settings have been saved.
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
• When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
• When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.

Tach Programming

About Tach Programming

If you press the
START
Remote Car Starter will make no attempt to start the Engine and the Parking Lights will
give 5 flashes.
AS-2360TW Installation Guide
Level 1
Customized feature
Level 2
Multi car operation
Level 3
Basic features
button.
LOCK
button.
TRUNK
button.
START/STOP
Table 5
LOCK
Table 6
Adjusting Honk Duration
button before carrying out a Tach Programming procedure, the
SHIFT
SHIFT
.
OFF
button.
LOCK
button.
UNLOCK
/
button.
START
STOP
button.
TRUNK
and
. If 3 honks are returned the new
UNLOCK
button three (3) times
button three
SHIFT
button three (3)
and
UNLOCK
START
P. 19

Advertisement

Table of Contents
loading

Table of Contents