Table of Contents
Advertisement
Remaining in ready Mode
Once the vehicle is in Ready Mode, you can start and stop the vehicle at wish.
However, should any one of the following occur, the vehicle will exit Ready Mode, thus
disabling remote start capabilities until Ready Mode is restored:
•
•
•
•
•
Should any of the above occur, Ready Mode will be cancelled.
Remote-start the Engine and listen for Starter drag. If the Starter cranks for too long,
carry out another Tach Programming procedure.
Hood Switch shutdown. with the vehicle running under the Remote Car Starter, open
the Hood; the vehicle should shut down. If it does not shut down, check the Hood Pin-
switch and its connector.
Brake shutdown circuit. With the vehicle running under the Remote Car Starter, press
and release the Brake Pedal. The Engine should shut down immediately. If the Engine
continues to run, check the Brake Switch connection.
Parking Brake shutdown circuit. With the vehicle running under the Remote Car
Starter, disengage the Parking Brake. The Engine should shut down immediately. If the
Engine continues to run, check the Parking Brake Switch connection.
Door Pin shutdown circuit. Make sure the Remote Car Starter exits Ready Mode
when each Door is opened while the vehicle is running under a Remote Start. (Test
each door.)
OEM Alarm Control. Make sure the Module is able to arm and disarm the OEM Alarm
(if applicable).
Door Locks and Trunk Testing. Make sure each of these options respond to the
Transmitter (if installed).
Starter Kill option. Sit inside the vehicle with all Doors closed. Arm the vehicle, then try
to start the Engine with the Key. They Engine should not start. If the Engine starts,
rewire the Starter Kill to reach proper operation.
Valet Mode. Make sure the Remote Car Starter is able to properly enter and exit Valet
Mode. When setting the Remote Car Starter into Valet Mode, pressing the Lock button
will lock the Doors without activating the Starter Kill. (Refer to the User Guide for further
information on Valet Mode.)
Idle Mode. Make sure the Vehicle properly enters and exits Idle Mode.
Most comebacks are the result of misunderstandings about how a product works or
performs. Take the time to properly explain all functions and features to the customers
before they leave the premises. Doing this will save time and money.
Closing Up
Use tie-wraps or screws to properly secure the Remote Car Starter and keep the wiring
away from any moving parts such as the Parking Brakes or Steering Column Shafts.
P. 22
Door opened,
Hood opened,
Brake pedal pressed,
Parking Brake disengaged,
Ignition Key turned to the
Remaining in Ready Mode
IGNITION ON (IGNITION ON / RUN)
Table 11
Installation Guide AS-2360TW
position.
Advertisement
Table of Contents
