The Programming Assistance Button; Programming The Transmitter; Before You Proceed; The Transmitter Programming Procedure10 - Autostart AS-1725 SH Installation Manual

Remember:
Once the Parking Lights are
ON
to 20 seconds to select a sub-menu. If you do not
select a sub-menu within 20 seconds, the Remote
Car Starter will exit Programming Mode and you will
have to flash the Hood Pin switch once again.

The Programming Assistance Button

Caution
The Hood Pin switch must be installed and connec-
ted in order for the Programming Assistance Button
to function. The button will work only when the
Hood is up.

Programming the Transmitter

Before you Proceed

The Transmitter of the Remote Car Starter is not delivered pre-programmed: it must be
programmed after the wiring of the Remote Car Starter is completed. The Remote Car
Starter has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be lost from memory. To erase all
Transmitter codes from memory, you must perform a reset of the Remote Car Starter
(see Resetting the Remote Car Starter, later in this Guide, for more details).
The Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
– Before the lights go out, turn the Ignition Key to the
– Immediately turn the Ignition Key back to the
2. Press and hold the
5 times quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
3. To exit: close the Hood.
P. 10
(solid), you have up
(A.k.a. the PAB.) Mounted on the Remote
Car Starter, this button can be used from
within the vehicle instead of the Hood Pin
switch in the Engine compartment. This will
spare the installer the trouble of accessing
the Hood Pin switch in the Engine
compartment.
for up to 20 seconds.
ON
OFF
button and keep it down until the Parking Lights flash
LOCK
Table 2: Programming a Transmitter
position.
IGNITION ON (RUN)
position.
Installation Guide AS-1725 SH