Tach Adjustments; Testing - Autostart AS-2360 TW Installation Manual

Manual transmissi on remote starter
Hide thumbs Also See for AS-2360 TW:
Table of Contents

Advertisement

Tach Adjustments

After having programmed the tach you might need to adjust it (increase or decrease
the idle speed). In order to do so, you will need to follow these steps:
1-
Flash the hood pin (see page 12)
2-
Enter the programming centre (see page 14).
3-
Press and hold the brake pedal
4-
Press simultaneously the
5-
With the brake pedal still pressed,
a. Press
b. Press
6-
Once you have obtained the desired idle speed, press
settings. The parking lights will flash five times. If the horn has been
configured you will hear one honk if the last button pressed was
honks if the last button pressed was
7-
Release the brake pedal and close the hood.
8-
The adjustment is done.

Testing

Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
installation and operation of the system. Before testing, make sure that all connections
are soldered and that the unit is plugged in.
Make sure the Remote Car Starter properly enters and exits Ready Mode:
Setting the system to Ready Mode
1. Ensure that all the Doors are closed and that the gear selector lever is in the
neutral position.
2. With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3. Within 20 sec. push
The Parking Lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press and hold either:
a.
LOCK
b.
UNLOCK
c.
START/STOP
AS-2360TW Installation Guide
and
LOCK
to decrease the idle speed, or,
UNLOCK
to increase the idle speed.
LOCK
,
LOCK
UNLOCK
to lock the Doors and shut down the Engine or enter Turbo Mode ;
to unlock the Doors and shut down the Engine or enter Turbo Mode ;
to shut down the Engine without affecting the Doors.
Entering Ready Mode
buttons.
UNLOCK
.
UNLOCK
Table 9
or
on the Transmitter.
START
Table 10
to save the new
TRUNK
and two
LOCK
P. 21

Advertisement

Table of Contents
loading

Table of Contents