Table of Contents
Advertisement
T W O - W A Y
AS-2310TW-FM
User Guide
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible
manner.
1. When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in
"Park" in order to avoid accidents upon remote
starting.
2. It is the user's responsibility to ensure that the
remote starter is disabled or put into valet mode before
servicing.
FCC/IC Notice:
This device complies with Part 15 of the FCC Rules, and RSS-210 of the IC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
DOC: 1.00 (i)
– January 4, 2007
L E D
A U T O M A T I C
R E M O T E
S T A R T E R
WARNING
DL Lp
T R A N S M I S S I O N
Manufactured in Canada by Autostart
Advertisement
Chapters
Table of Contents
Related Manuals for Autostart AS-2310TW-FM
Summary of Contents for Autostart AS-2310TW-FM
- Page 1 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. DOC: 1.00 (i) – January 4, 2007 DL Lp Manufactured in Canada by Autostart...
- Page 2 The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. P. 2 User Guide...
-
Page 3: Table Of Contents
Table of Contents Introduction........... 3 Ignition-Controlled Door Locks ....8 Ignition Re-lock........... 8 Using the Remote Control ....4 Secure Lock..........9 Vehicle Presets ........4 Remote Trunk Release ......9 Heater & Heated Seat ........ 4 The Starter Kill and the Anti-grind Feature. 9 Windshield Wipers &... -
Page 4: Using The Remote Control
Using the Remote Control Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page 10). The functions of the transmitter are as follows: LED #2 LED #1 LED #3... -
Page 5: Arming The Starter Kill
Arming the Starter Kill The starter kill (if installed) can be configured by the installer so as to arm automatically (passive mode) or not to arm automatically (active mode). • To disarm the starter kill, press the button on the transmitter. UNLOCK The parking lights will flash twice. -
Page 6: Valet Modes
Valet Modes When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being remote-started accidentally. Ignition Valet This feature will allow you to remotely put your system into valet mode by using the ignition key instead of the valet button as above. -
Page 7: Quick Lockout Tm
Quick Lockout (Also called secure panic.) For fast protection in emergency situations, the system will LOCK doors when you press the brake pedal while you hear the sound signal. (Quick lockout is only available when panic mode has been set off.) Cold Weather Mode When cold weather mode is active, the engine starts every 2 hours and runs for 3 minutes (or for 8 or 20 minutes with diesel engines). -
Page 8: Feature Confirmation Chart
Feature Confirmation Chart A visual and audible confirmation is emitted each time a command is sent. The following chart indicates the confirmation sequences: Feature LED #1 LED #2 LED #3 LED #4 Beep(s) Lock 3 flashes Unlock 3 flashes Trunk 3 flashes LED ON/OFF 3 flashes... -
Page 9: Secure Lock
Secure Lock Before it can remote-start your vehicle, the remote starter must first disarm the factory security system. The secure lock feature may be required on certain vehicle models with factory security systems that automatically unlock the doors when the security system is disarmed. To keep your vehicle protected when the factory security system is disarmed for a remote start, secure lock will relock your doors as soon as the vehicle has started. -
Page 10: Turbo Mode
To take the system i n t o home valet mode: • Press the button. LOCK UNLOCK • Within 3 seconds, press the buttons simultaneously until the LOCK START/STOP parking lights go out To take the system o u t o f home valet mode: •... -
Page 11: Multi-Level Features ( Default State)
Press buttons simultaneously:......TRUNK LOCK LOCK Press simultaneously:........TRUNK UNLOCK UNLOCK Press simultaneously TRUNK START/STOP : ........START Press simultaneously ......TRUNK START/STOP STOP Press ..........SHIFT SHIFT TRUNK: TRUNK Press :..........SHIFT SHIFT LOCK LOCK Press :..........SHIFT SHIFT UNLOCK UNLOCK Press SHIFT... -
Page 12: Vehicle Status Request
Option 3: Level 1 Customized features (requires pressing the button 1X) SHIFT Level 2 Multi car operation (requires pressing the button 2X) SHIFT Level 3 Basic features (requires pressing the button 3X) SHIFT Option 4: Level 1 Basic features (requires pressing the button 1X) SHIFT Level 2... -
Page 13: Status Request When The Engine Is Running
STATUS SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s) sequence if 3 flashes locked Home Valet sequence if 3 flashes unlocked sequence 1 second 1 second sequence if 3 flashes locked Valet Mode sequence if 3 flashes unlocked sequence 1 second 1 second... - Page 14 • Always hold the transmitter high, approximately at shoulder height. Holding the transmitter against your chin will also increase your range: your head acts as an antenna. • The operating range will be somewhat lower on vehicles equipped with an aftermarket or factory alarm.
- Page 15 Diagnostics – Parking Light Flash Table Flashes Description • Doors locked, starter kill armed • End of run time • button pressed TRUNK • Start signal received by the module • Cold weather mode cancelled • Doors unlocked, starter kill disarmed •...
Need help?
Do you have a question about the AS-2310TW-FM and is the answer not in the manual?
Questions and answers